Thanks for the idea but I want the gauge for my original 12-160 panel.
I'll post a pic later today.
Pete
Sorry that I don't have an extra temperature gauge but the picture of you instrument panel provoked this question. Mine is virtually identical, except that my temp gauge is a SW. Now for my question: when facing the instrument panel, there are seven holes for the gauges and so forth. Looking directly at the panel, from the left there are two 3/4" holes in the first and third positions. I believe the "gas" knob goes in the the number three hole and the "choke" knob goes in the first. I am missing the choke knob but am in hot pursuit of a replacement.
The the fitting on the gas knob has a diameter that is too small for the hole on the panel. And I don't know what the original fitting on the choke knob might have been.
Do you have all the knobs and if you do, what are the fitting diameters?
Any help you can provide would be appreciated...
Don's car is an 8-105 so may be different. I'll have to dig in my manuals to see.
 
I'll look to see if I have an extra gauge for you too Pete!
Hi Justin
Thank You for the clarification; I don't know what made me think it was a 12.
The dwg and pic of the bezel is correct for 8-105 but I am not sure on the locations of the knobs. Randy would know for sure.
Thank You for checking re temp gauge.
STAY HEALTHY
Pete
Thanks for chiming in...and for the photo of the cluster. Mine will be identical once I obtain (1) a choke knob; (2) the proper bezel for the first "gas" hole; and complete the rebuild of the two-way toggle switch that is mounted on the lower edge of the instrument panel.
WTB a choke knob if anyone knows who might have one!
 
Thanks for all the comments...very helpful!
SURE
Check your Personal Messages
Pete
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.











