Those bearings are obsolete, but someone may still have some around. You can also substitute with a little work a standard (straight thru) needle bearing instead of the cup type. You will have make an end cap to close the end off. Many also add a grease zerk setup to facilitate external greasing. In some past newsletter articles. I think this grease zerk conversion was highlighted.
M
· Oct 23, 2014
Thanks Pat for verifying my post about these no longer being available. I have always wondered why no zerk grease fitting was part of these bearings. I may try to make this modification but will it be a judging points off deduction if my car is ever judged. Fabrication of an end cap will be simple too.
M
· Oct 24, 2014
Hi,
 
I have not replaced the trailing arm bearings on 1509A, but I did give some consideration to installing a bronze sleeve in lieu of the needle bearing. Has anyone done this? And with what results?
 
--Tom
M
· Oct 24, 2014
Have two NOS M-28241 bearings, $100 ea. plus shipping. Bill Bicknell email
M
· Jan 9, 2015
That price for the bearings sounds very good.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.