Hi, try Wheel Smith in California 1- 800 -854- 8937
Tech phone 1- 951- 898- 4563
Good luck
Pat
Do you have the correct bolt pattern for original wheels?
CORDially Mike
What he needs is, original center hubs. The rims and spokes are not importent.
If he supplies the hubs to Dayton wheel, they can make him new ones.
Curt, that is correct. Once I have original center hubs, I can fit original hubcaps on it. The bolt pattern I use is 5x 4.5. The original Auburn pattern is 4.25? If that is the case I would be still able to make Auburn pattern fit to my actual pattern by changing the pattern on my wheel hub itself.
The question is still, where to get original hubs.
Thanks
Szilard
PatI completely agree. This is a classic example of modifying the right part to accept original components as opposed to trying to convert to original Auburn components un-necessarily. In this example, the bolt pattern of the nuts holding the wheel on the replica are 5 x 4.5. And the new rim you buy should have that bolt pattern in my opinionI do not know the original bolt pattern for an original Auburn - no one has told us that measurement yetsomeone like Curt or Mike should provide that info if they can. I imagine it is most likely an uncommon size and will therefore increase the cost of creating the wheel look you want. A 5 x 4.5 bolt pattern is a common Ford lug nut spacing (like on my replica). So it will be quite easy to buy a wire wheel with that specification. Usually the wheel diameter is 15 inch, which matches most replicas. Another consideration is the wheel offset.
But in my mind the big issue is, how do you get a center cap in the wheel that can accept a center cap that has the beautiful Auburn 8 logo stamped into it. That logo is hard to find. No doubt Curt has a beautiful reproduction of that stamping on a center cap. His attention to detail on other parts have been superb (in my opinion). So if he sells that center cap (as shown in your photos), we need to have a measurement of the diameter of the center cap, along with the diameter of the raised section that snaps into the center part of a standard auburn wheel. This will tell us if an adapter is required to be machined..I have a feeling that willbe required.
Curt.can you provide the dimensions of any center hubcap you sell?
I agree to choose a set of wheels with ford pattern. It is a 2nd gen anyways so it would be a waste to try to put original wheels on it. What counts for me is the look and for that I would like to combine the wheels with Auburn hubcaps. I am ok to proceed with any wheel that is of good quality and the right look. Can be Dayton, Wheel Smith
 
Curt, what was the result of your measuring - if you would like to share. I am happy to call you alternatively..
 
Thanks
Szilard
Thanks to all of you! I decided to order 4.5 bolt pattern new wire wheels and try to adapt the Auburn Hubcaps to them.
I will keep you updated and am happy about the great support here!
Szilard
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.




