I'd like to add something important to what Terry has posted. Our Cord engines have a vacuum being pulled on the crankcase. This is done by the oil fill tube copper line going up into the air filter area. Its not 24 inches of vacuum but enough to make a negative on the crankcase. This helps pull oil back into the engine from the rear oil seal.
 
 
Gary Parsons
I find it interesting that the parts manual list the following:
A 90673 Packing - crankshaft front bearing cap
Anyone ever find any packing on the main bearing cavity or is this somewhere else?
Pat Leahy
Terry - the drain line is on the front main bearing cap.
 
Pat - I've never seen any packing. I don't even know where you would put it as there is no place for it. 
Good point Jim. I answered the Posting too early this morning.
Besides I didn't sleep very well last night.
I will try to be more accurate.
 
At the firewall end of the engine, it is sealed with the timing case and tachometer drive. 
The drain pipe and partial vacuum stop oil from escaping from the front of the engine adjacent to the flywheel.
George, I think you are right. The parts list call the right and left gasket for the pan on the bottom of page 5. but no mention of the gasket around the bearing cap. 
 
When I first looked at it I thought the gasket for the crankshaft front bearing cover gasket (page 4) was that thicker gasket on the bearing cap but now looking at it that would be the thin gasket under the plate (I forgot about that). 
A related part of the crank case ventilation system is the rolled screen in the copper vent tube. Make sure this screen is clean. It tends to get sludged up. If clogged it will undercoat your car with oil.
See Newsletter 1998 No 1 Page7.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

.jpg.43625d615eab97dea93e7448cba5df7c.webp)
