Hi Bill. The wiper motors are fitted with speed controllers. Have you tried adjusting them as they may be screwed in closing off the vacuum ? If they were working they should continue to do so. You could also check the vacuum line down to the inlet manifold for continuity. You could also try working the wiper arms by hand with the engine running and the wipers turned on.
Another thing to try is connecting the vacuum line to your modern driver.
If all else fail you will have to go in by lowering the head lining above the windshields.
Others may have some more options .......................... Good Luck.
Take care during your recovery.
I really can't add anything to what Terry has posted. If you can establish you have good vacuum then I would try the speed controller. You or somebody may have "adjusted" it not knowing what it was.
Sorry about the surgery but hope you recover fast.
 
 
Gary Parsons
Try shooting a little WD-40 in the line they usually have leather bellows for lack of a better word and this dries out with disuse.
Mike
Just remember If you put WD40 in the line and run the engine, you will be lubing your intake manifold as it is vacuum. If you put WD40 on the line and blow it into the wiper motor that might work.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
