Terry its amazing what we find that works. Heat has always worked well for me in the machinist industry. One of my jobs required me to install a metal bearing sleeve that was 1 inch thick by 20 inches long by 24 inch diameter. The press fit was 1 1/2 thousands. I used a rosebud to heat the ring to 250 degrees making sure not to overheat it by turning it blue anywhere. I kept using inside tub-lair mics checking the inside diameter. When ready the bearing ring using Kevlar heat gloves was slid on the shaft. It was so loose from heating we always had to wedge it in place against the bearing land so it won't grow away from it as it cooled. That was simple compared to installing the Timkin tapered bearings in the 5 ton housing that was 28 inches of solid metal. Heating that piece took three guys using propane weed burners. We used an overhead crane to lower those bearings in the housing. I recall they weighed something around 6 thousands lbs each. Getting the old damaged bearings out usually was simple. We used high pressure grease guns around the housing. The grease hydraulic pressure would push out the bearings.... Sometimes... Other times it was air arcing them out. Noisy, smelly and hot as you know what...
I try to use a light grease on any taper fit. Most have no idea how much a taper fit holds pieces together till they try to take something apart. Every try to measure the taper fit on a crank dampner.... Thank god as they are being removed the fit gets looser....
 
 
GaryParsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
