Hi Tom,
 
If you can get a solid pedal after you pump the pedal a couple of times the problem is not the master cylinder. You have air in the brake lines. the way the brake lines are laid out on the 810, it can be very difficult to get the air out of the lines using the manual process of pumping the brakes and holding the pedal while someone bleeds the wheel cylinder. 
 
Try using a pressure bleeder to bled the brake lines. You can get a an inexpensive one from Motive Industries that makes the bleeding process go very quickly with very good results. 
 
If you still have a low pedal after you bleed the lines then you may need to adjust the brake shoes. This can be a real pain on the Lockheed brakes, but once they are set the brakes work well.
 
Jim
I bought this one to convert mine to dual circuit. Have not installed yet but based on some old forum posts the bolt pattern should be direct swap.
Roadster Supply Co.

Dual Reservoir 3 Bolt Early Ford Master Cylinder

I would argue against the conversion. The originals have worked great for decades.
I recommend this conversion as it makes our vintage cars safer. AMC was the first with this dual system. Governments soon mandated it for all manufacturers .

George van NostrandAug 7, 2025 I recommend this conversion as it makes our vintage cars safer. AMC was the first with this dual system. Governments soon mandated it for all manufacturers .
Are you installing a roll bar? That would make it safer too.
The change will make you "Feel safer" but the math may say otherwise.
I am not installing a roll bar. My opinions are based on my experience as a Certified Mechanic , plus 35 years of operation of a service garage specializing in front wheel alignment , brake service and safety components.
George.
I tend to agree with both sides of this issue. If... And only if you have no plans to enter your Cord for judging I agree with go ahead and do the master cylinder upgrade. But contrary to that the original brakes have worked fine for decades but ONLY if they are set up correctly. I have an 89 Ford diesel crew cab. The master cylinder is a 1 inch bore. The rear self adjusting brakes have been problematic since they were used on these trucks. Come to a stop light and feel the truck begin to creep into the crosswalk. So we apply more brake feeling the peddle slowly sink towards to floor. To "fix" this engineering issue we need to use a brake spoon and manually adjust the rear drum shoes. Or we found out installing the hydroboost 1 1/4 inch master cylinder is the best fix. Theres more than just bolt in but the larger bore master cylinder has solved the rear drum brake issues and no more creeping into crosswalks. Engineering changes require some thought before doing them. But asking questions and doing plenty of research has worked.....
Gary Parsons
The originals have worked fine for decades but we are now driving in 2025 traffic and any improvements we can do to our 89 year old cars to make them safer to use is good. If our cars are only loaded or unloaded from trailers then the originals are fine.
Tom
There have been a lot of comments on this subject. The dual master cylinder will not improve the the performance of your brakes on the Cord 810/812.
The benefit of the dual master cylinder is if there is a brake line failure (or you blow a wheel cylinder) you only lose your brakes on two wheel instead of all 4 wheels with the original system. Remember you still have your rear brakes with the emergency brake handle.
While the original brakes on a Cord 810/812 are not as good as modern brakes they work fine as long as they are rebuilt, adjusted and maintained properly.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
