Thanks for sharing this. Best I can tell mine in my 37 Cord probably is from the late 1949 time frame. So it "could be" original. Someone before me used some black electrical tape on the wire.Guess it was failed. It looks like its ready to fall off. Happy to note I replaced it during my distributor restoration.
 
 
Gary Parsons
You have to look at applications, not voltage. Condensers apparently aren't sold based on voltage, and that's why the clerk may have been confused. Asking for a Auburn 8 cylinder condenser" will produce results. Yes, it is still in the NAPA books.
Condenser s don't know voltage 6/ 12 does not matter.
What's important on condensers is microfarad. NAPA knows that if you get the right guy. I always buy asking for microfarad and pig tail length. Some cond. have too short a pigtail but the right microfarad. Curt is right about 6V or 12V, cond. doesn't care.
CORDiallyMike
That is interesting Mike. I didn't know about the pigtail length. The s/c cars have a longer pigtail than the non s/c eight as it is in the distributor.
The sixes hang outside as well.
The capacitor / condenser, is a tuned circuit with the inductance of the coil. Therefore the farad (micro, micro micro (pf for the under 50 year olds) or Nano for you new guys) rating of the condenser is the important specification. Voltage will never be mentioned in ignition circuits. The farad rating of the condenser affects the wear of the points, as it affects the current in the circuit.´╗┐
Paper capacitors get moisture in them (paper insulator absorbs water when the wax fails) and causes low resistance or "leakage" failure between terminals. Mylar and polyester insulators much better. Some can go bad sitting on the shelf, others work for years. You can test them, with these new Fluke (or other brand) DMMs. Check the Farad rating, and if that is in range, check the resistance. It SHOULD be infinite or at least megohms. I have at least 40 in stock new and NOS none are marked with a voltage.
Where is the website. I'd like to read their opinion.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
