

Eric
 
The original was a rope packing
Packing generally used now is square  graphite impregnated packing, You'll need about 3 rings. Its a 3/4" shaft and the OD of the housing is 1.500  so I would try 3/8 x either 1/4 or 5/16"
I wouldn't  use anything with teflon, especially if the shaft has been replaced with 316SS !!!! Lots of  opinions against Teflon if you search but others experiences may vary.
Cut the ends of each ring  at 45 degrees , not 90 .
Don't over tighten!, not much more than hand tight and you will  have to adjust as the new packing wears in .
Be prepared to accept some drips, they  always drip and its better to have some drips than over tighten and wear the shaft.
 
Hopefully, the shaft is in good condition and the 'nose' bearing isn't too worn . This is the biggest design flaw of these pumps, The 'nose' bearing is a plain bronze bearing with no lubrication. The more wear in the bearing , the faster the packing starts leaking again.
 
 
Brad
What's the diameter of the water pump shaft? The Model A guys have these neat pre-made 5/8" ID graphite rings that work rather well. I use them on my Lincoln.
 

https://www.snydersantiqueauto.com/product.htm?pid=979269&cat=41793

Matt HarwoodFeb 8, 2025What's the diameter of the water pump shaft? The Model A guys have these neat pre-made 5/8" ID graphite rings that work rather well. I use them on my Lincoln.
 
https://www.snydersantiqueauto.com/product.htm?pid=979269&cat=41793
Thanks Matt.  I read your entire post cover to cover and very helpful.  PS.  I keep trying to be a customer and follow your inventory weekly.

bradsanFeb 8, 2025Eric
 
The original was a rope packing
Packing generally used now is square  graphite impregnated packing, You'll need about 3 rings. Its a 3/4" shaft and the OD of the housing is 1.500  so I would try 3/8 x either 1/4 or 5/16"
I wouldn't  use anything with teflon, especially if the shaft has been replaced with 316SS !!!! Lots of  opinions against Teflon if you search but others experiences may vary.
Cut the ends of each ring  at 45 degrees , not 90 .
Don't over tighten!, not much more than hand tight and you will  have to adjust as the new packing wears in .
Be prepared to accept some drips, they  always drip and its better to have some drips than over tighten and wear the shaft.
 
Hopefully, the shaft is in good condition and the 'nose' bearing isn't too worn . This is the biggest design flaw of these pumps, The 'nose' bearing is a plain bronze bearing with no lubrication. The more wear in the bearing , the faster the packing starts leaking again.
 
 
Brad
Brad, as always very helpful.  Randy Ema said mine should be 1/4 so I am going to order some of that and see how it works.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
