Not glamorous, but I have used washers and stainless steel screws with the head ground down a touch (works fine until you have to take it apart).  
 
Eagle Extrusions stocks half oval stainless but it is solid, not for use with clips.
Possible source vendor:
Max Merritt Auto / Packard Parts 
1456, 235 Terra Haute St.
Franklin, In.  46131
 Ph. 1-317-736-6233
Fax  1-317-736-6235
 
 
Franklin is approx 20 mi so of indianapolis ,
 
 
Good hunting     dws Nvl ....
Somebody in the Auburn club reproduces that trim. Gilliland maybe? Call Mike Samson 847 987 2928  Tell them what side you need . Maybe Jay Engler in ACD club has it
Thanks for the options, I will make some calls. Someone also pointed out the trim on a early 60's VW is the same dimension, it was cheap enough so I ordered a kit to see how it looks.
The cowl trim on my 31 is solid, three pieces. 
CurtiFeb 2, 2019The cowl trim on my 31 is solid, three pieces. 
If its solid, its replacement . The originals were a stamping and  even have a very small L or R stamped in them to ID the side. My source of knowledge is a original 32 8-100 A phaeton and a 32 8-100 A sedan.
I have to be respectfully disagree. It could be one of the differences  between a car built in Auburn vs Connersville. My source of knowledge are two unmolested cars : 31 898-A coupe  61 K miles   32 8-100A sedan 19,300 miles.  
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
