Are you SURE you timed it on the compression stroke? Just because the pointer on the flywheel is at 1/8 doesn't mean it is on time. Remember the cam goes around twice for each time the crank goes around.
I am absolutely positive. I checked this out by pulling plug number one and putting my thumb over the hole. I get a pop at top dead center and it matches the flywheel
My thought is you've found number one TDC but have timed it to the wrong wire on the cap. Please remember to turn the distributor the the opposite direction to the rotor's rotation till the points open. That should get you going. Once the motor is warm you can time it by using a vacuum gauge
Thank you for the response. I am 100% certain that the timing is correct. Does anyone know what the compression should be on this engine?
When you did the test you outlined in 6) above, when you turned the engine over, did you use the starter or did you hand crank it? It could be a bad coil or weak battery, even though they are new. If you got a spark by hand cranking, try the same test while turning it over with the starter. A bad coil might put out a good spark when it has all the current from the battery- but if the starter is drawing off the battery too, there might not be enough to make a good spark.
Thanks for the response. I turned it over with a fully charged 6 volt battery. Thinking of using an 8 volt battery. I am going to check compression on all eight cylinders also. Does anyone know what the compression should be on this engine? How much compression is needed to start it?
Nick, did you ever get your engine started?
No, I have not gotten it started. Took a little break and started working on another car. Plan on getting back to this one soon. I did just get new points and have not tried that out yet
The compression should be roughly 15x the compression ratio of the engine.. so if it has a 5.0:1 compression ratio then you should have around 70-75psi compression.
Double check your other set of points to make sure they are opening as well.
You CAN have compression if the cam is several teeth off, if it is possible, look at the cam timing marks. If not, then when #1 cylinder is on TDC, then #8 will be on crossover. The exhaust valve will be just closing and the intake just opening when the piston comes up to TDC. You should be able to watch the valves through a spark plug hole.
A rotor can have a crack in it, and be shorting the spark to the distributor shaft.. Look at the rotor for carbon tracks.
If you pull a coil wire, and crank the engine over you should get equally spaced sparks from the coil. If you get one, then a weak one, then none, it usually is the condenser. Make sure the distributor is well grounded, and the condenser is also tight and grounded.
Let us know what you find.
GLong
Thank you for your help and suggestions. I have been working on another car and have not tried starting this car. Hopefully I will get back to it soon
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
