The fluid is colored alcohol. To get the proper expansion ratio, you need to use very high quality alcohol (95% or higher), not the common stuff found at your local drug store. The joint between the glass and copper tube is/should be a permanent connection created when the glass is formed onto the tube. Before refilling with alcohol, you will need to repair the glass/tube connection or make an entirely new piece. The glass/tube sub-assembly should be attached to the main capillary tube with a soldered joint.
To refill the capillary tube, pour some alcohol into a small cup. Fill a larger container with ice and a little water. Submerge the open capillary tube end (not the bulb end) in the alcohol. Place the capillary bulb end into a pot of boiling water. Once all the little bubbles have stopped coming out of the open submerged capillary tube, remove the capillary tube bulb end from the boiling water and place it into the ice water, make care that the open end of the capillary tube stays submerged in the alcohol during this process. Wait about thirty seconds and then remove the open end of the capillary tube from the alcohol and solder it to the glass/tube sub-assembly, all the time keeping the bulb end submerged in the ice water.
To perform this process successfully is beyond the ability of most individuals. That's why most people send their gauges out to a professional shop for repair.
Hello, new here. What red and green fluid should go into the gas/oil level glass gauges on a '34 Auburn. The glue holding the glass tube to the small brass funnel didn't hold and the both fluids leaked out. What were they filled with originally and what can I replace them with. Also what kind of glue will bond glass to brass? Any help or a link to the same kind of question here on the forum would be appreciated.Keith
1934-1936 Auburn six and eight cylinder used red fluid in both the gas gage and the temp gage. I am not sure exactly what the chemical composition of the original fluid was, but I can say with certinty it was very corrosive. Alcohol seems unlikely because the top of the glass tube is open to the atmosphere.
Evaporation would occurr. The red fluid is available for the King Seeley gas gages; but be cautious, much of the fluid being sold comes in a black envelope with a notation 'Do not expose to light'. It will turn clear in a short period of time and will be all but invisable in the gage. I haave working gages in my Auburns. If assistance is needed, send me a email or PM.
They used a clever trick to attach the glass tube to the copper originally. First you have to get a clean etched surface on the end of the glass. then you get graphite powder into the etched surface. That is electrically conductive, and you can electroplate this with a nice coating of copper, which is bonded to the glass and can be soldered readily. Any other method may be unsuccessful. If you cannot find a supplier of home electrplating supplies and equipment, you can get what you want including full instructions from janekits. A lot of restorers here in Australia use what they provide, because the results are good, and you have no loss of small parts while they are beyond your control. Phil Irving, designer of the championship Formula 1 Repco Brabham engines once advised us that if you alter things, you will likely learn in the end that the designer was right in the first place.
Very interesting Ivan. I have a small supply of clear fuel gages, BUT the temperature gages are another matter. In a 1934 - 1936 Auburn the gages are the same except one is inverted. I would suspect the sealing process would be the same. Except the tempgage glass tube is sealed on the top. I would imagine a good bit of pressure.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
