I didn't realize these cars had been created so long ago!
Those wheels are excellent
I didn't have this issue with 1.03, but when trying to print, the software can not get the bed up to 100c. It just hovers up and down around 95c. I doubled checked my hardware, and used Pronterface to set it to 100c, and no problems. After getting it to 100c with Pronterface, I switched to Creator, and set bed temp to 100c. It had no problem holding it until I sent the gcode ]to print. It than dropped down to 95c and hovered around there. It could not get it to temp, and would not start the print. Anyone else with this issue?
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
