I once had something similar happen to me with the same symptoms on one of my Cords. I was able to find the problem. The fuel pump diaphragm was starting to come apart and some of the pieces found their way into the carb bowl . They then would block the carb jet starving the engine of fuel and it would quit running. After sitting for a short time with the fuel bowl lowering, the jet would be cleared and it would run fine until the pieces of the diaphragm blocked the carb jet
Orphase again.

These intermittent problems require a diagnostic process. It sounds like fuel supply, but it could be ignition. Instead of guessing, I suggest that you check the fuel pressure while the problem is happening. To do this, temporarily plumb in a fuel pressure gauge that is visible to the driver. It should be connected to a T fitting between the fuel pump and carburetor. Then drive the car until it begins to stall. If the fuel pressure drops off, pour ice water on the fuel pump and carb. If it quickly recovers, you have a vapor lock issue. If not, check the pump, lines, hoses, and pickup in the tank for obstructions or air leaks, check the fuel pump with a hand operated vacuum pump and gauge tool connected to the inlet port of the fuel pump. If it doesn't hold vacuum pretty good, you have a faulty fuel pump.
If the fuel pressure remained steady during the driving test, it could be an obstruction in the carb/needle and seat. Or it could be ignition. Coils and condensers can fail from heat. Have a good spare spark plug with, and when the car stalls, jump out and plug one of the plug wires into the spare plug with it laying on the head and crank the engine and check for spark.
I know that in my experience with antique motorcycles the first place to look when that problem occurs is the fuel tank vent. I do not know how the Auburn tank is vented.
Tom
This problem can also be caused by junk in the fuel tank. When you start to drive the car the "junk" has settled to the bottom of the tank. As you drive the junk gets stirred up and blocks the tank pickup and the car stalls. After you let it set for awhile the junk settles and opens up the pickup.
, and it starts all over again.
CORDially Mike
I found my electric pump was restricting flow after I turned it off. The manual pump was not able to pull sufficient gas through the aftermarket electric pump and filter.
I mapped out a fix and not long after found the same suggestion in a very old club newsletter: isolate the electric pump with check valves. Problem solved on both my '31 898 and '34 12.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
