Hi Rick.
I'm not very knowledgeable about Auburns however I would suspect that the cast space is not an original part.
Others may correct me on this but usually the rear axle mounts directly with the springs.
When you do have the springs re-cambered they should be done hot. Some shops do cold bending however over time the springs will return to the original settings.
Thank You Terry -
Do hope that someone with a Phaeton has  a look underneath as in 1931 the lowering of the 8/98 profile was a marketing story
The cast spacer has thrown me as it has been cast with a hole in the top for the locator pin and a pin shaped protrusion in the bottom to locate in the top leaf. It looks authentic??
Will make sure i don't get a cold bend job..
Regards 
Rick 
Rick try contacting John Ehresman he is listed as the Auburn Technician for 1931 to 1936.
jmehresman.ad.com
202 735 5580
Thanks Terry and will call at a sensible time for DC !!
regards
Rick
Hi Rick.
I didn't put the correct email address.
It's ........................ jmehresman@ad.com
You are probably better calling him direct .
Let us know the outcome.
Cheers from Down Under,
Terry
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
