Hi Steve. Looks like a major problem if most of the oil in the gearbox has leaked out. Normally there are lipped seals fitted either side of the differential. These stop gearbox oil entering the inner CV joints. I have read that some owners have removed these seals to run the inner CV joints in the gearbox oil. You will have to remove the drive shaft assemblies to replace the seals. The seal in the CV joint cover will have to be investigated too.Check out the gearbox exploded view drawing to see the seals. Part No 73
Hi Steve, I have to agree with Terry and Pat. Your best bet to to dig in and find the cause of the leak. First would be to pinpoint where the oil is leaking from. Make sure all the screws holding the inner CV joint housing to the transmission are in place. It's usually not that simple but sometimes you can get lucky. From your photos it looks like it's coming out of the Inner CV joint cover. This means you need to pull the front wheel, outer CV joint and inner CV joint. At that point clean things up and take a good look at everything. Is the differential seal in place? Is the seal in good condition? Is the CV joint where the seal rides worn? Check the inner CV joint housing seals - It appears these are worn and need replacing.
 
This inspection will tell you what needs to be done to correct the leaks.
 
I wouldn't try the Transmission stop leak. These are formulated for modern transmissions, not our old gearboxes. they probably won't work on out Cords, and if they did it wouldn't be for very long.
 
JIm
Steve you are not too far from Mark Clayton in Castle Rock. He runs one of the top restoration shops in the US specializing in 810 812 Cords.
He is in the directory. He will be able to sort out all of your problems.
 
I think the best way to flush the gearbox out is to fit high powered magnets to the drain plugs. They pull all ferrous metal particles out of the oil.
 
You are fortunate to have Mark close by.
Hi Steve, I know the car. I have seen it many times, I wondered where the car went.
 What is the tar like coating on the oil filter? That shouldn't be there and I wonder where it came from? That filter will separate from the cover, it is just pressed together. Taking it apart makes it easier to clean. 
Jim 
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.




.jpg.a0038bae113ca50a0b36e939c74868c1.webp)