

For all sorts of reasons for which I am personally accountable for, I am not there yet so I can't help you.
Someday , I hope to have the same issue!
 
Keep posting photos and topics because they are motivational.
I think all old cars have their own unique idiosyncrasies especially when it comes to starting.
I installed an electric fuel pump to lessen the cranking to get gas to the carburetor and use it whenever the car has been sitting or if it begins to vapor lock.
My procedure for my 1932 Auburn;
Cold is fill the carb with gas, full choke, full spark advance and a little throttle. After starting push the advance in and start pushing the choke in.
Warm normally all I have to do is full spark advance and a little throttle.
Good luck.
CRD
 
On the use of the spark control .
Is there any info in the 1932 owners or service manual? 1931 service manual is completely silent on its use and function .
I don't doubt your procedure works for you and will work for Eric, just curious that Auburn completely ignored its existence!
I was involved in this earlier discussion :
https://acdclub.org/forum/auburn-acd-forums/7832-checking-timing-8-98-amp-manual-advance#31311
There was a prior discussion on the use of the spark control

It's just that I found the control counterintuitive coming from the early Buick and Model T world. For those cars the spark is retarded in the 'stowed' position and advanced when you pull a lever down ( which I would equate to puling a knob out ). The Auburn is advanced when the knobi is stowed. it does make sense that, with the exception of the headlights, all of the knobs on the dash for 31-33 should be pushed in to run and pulled out to various degrees to start. The 1931 owners operating instructions talks about HEAT, CHOKE, START in the starting procedure but does not talk about either the GAS or SPARK knobs being used. On cars without mechanical weight advances Model T's and Buicks, you retard the spark when hand cranking and then adjust for best running condition .
My understanding is that with modern fuels, the HEAT control is pretty much not used .
Could be the fuel pump diaphragm ? Depending on whether it was ever rebuilt or when it was rebuilt, it might have an ethanol fuel compromised diaphragm.
Then and Now Automotive sells kits with ethanol resistant diaphragms. If you have the original Stewart Warner pump, be careful with it lest you get an education in pre-war pot ( diecast ) metal .
Brad,
The 1932 Auburn manual doesn't say anything about advancing spark or giving it throttle, but my procedure works for me.
 
Elipper before pulling the tank I would check for a small leak in the line that could be sucking in air and double checking the fuel pump diaphragm like Brad suggested.

Agree if the process works for you , keep doing it !I wasn't questioning your process, I just think its weird that there are only 6 knobs on the dash to talk about and Auburn didn't see fit to talk about 1/3 of them !While I was trying to be careful and researching my comments I came across this interesting tidbit. I'm sure I'm not the first person in the past 70 years to have discovered it but since it is a good reminder that even original documents cant be trusted, here you go: I attach the frontispiece of the 1931 Use and Operation manual and the same thing from the Service Manual. Can you spot the difference and which order is correct?
I know they are too grainy, I've driven myself crazy trying to edit and upload better quality photos but the site won't let me . Most times, it seems 50/50 on whether the submit button wants to work.
Tried to raise these issue in a different section but, again, I can't hit submit to do so!!
 
I'll repost if I can get access.
 
BTW, this response is via 'quick response ' which seems to have a functioning submit button
GAS and SPARK knob positions are reversed .
Both appear to be photos as opposed to drawings.
Not sure which the club considers correct!
This forum took alLof my fun away!!!
 
BTW, there is no mechanism to add attachments in 'Quick Response'
 
Brad
Yesterday I was unable to post a response thru the SUBMIT button too. My posts were confined to an aera 4 wide by 6 tall to the left of the posting page. But today I have everything normal again... No idea why. But glad my system works again.
 
 
Gary Parsons
The spark should be retarded to start, not advanced.
CORDially Mike

I had my 8-98 for about 10 years and never adjusted the timing using the dash pull. It started instantly several times in a row and proved it in front of the Auburn Hotel. I had the throttle pulled out to just a little more than idle and the choke pushed in, trans in neutral with the e-brake on and would reach in the window, turn on the key,, give the start pull a quick pull and it would be running EVERY TIME!
Each car has its own personality and when it has trained you it will not be a problem.
My car only ever used the SW fuel pump with the original Schebler carb.
Pete
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


