

In my opinion, not an expert;
 
plugs Champion C-4 is correct
 
wires correct
 
chrome fitting on spark plug correct
 
Stromberg URO-2 carb is correct for '32 while Schebler T51 or is it TX 51 is correct for '31; Most people prefer URO-2 but my '31 with the Schebler ran perfectly with only 2 exceptions when I let it run out of gas( I don't blame the carb on that)!
Pete is correct;
Champion C-4 for the spark plugs.
Stromberg URO-2 carb is correct for '32 while Schebler T51 or is it TX 51 is correct for '31
Unless things have changed since I judged the spark plug ends can be tricky. Rule of thumb is on 1928-1936 they are brass. However there are exceptions. Exceptions being 28-30 Big 8's are chrome, 28-30 small 8's used spark plug boots. 31-36 Speedsters used brass or chrome. 12's have clip on or bayonet type ends.
The spark plug wires on 28-33 have yellow-orange wires with black tracers or 31-33 also used black. However the wires must be cloth covered over the rubber.
Good luck and hope this clarifies some of the confusion.
Agree with CRD.
What plugs was it running before you changing them out.
Besides the chrome issues, and others can chime in, the routing of the vacuum line to the Bijur unit is one I haven't seen before. Usually see it routed to the rear. I only mention it because your attention to detail on the Opel is out of this world!


I think I have 1; I'll look tomorrow.
Pete
I dug my way through 24"+ of snow and looked but not there so must have sold or given away.
Sorry to get your hopes up
Pete
Eric
 
Have a look at Larry's post on the AACA fixing a split packing nut for a carburetor.
https://forums.aaca.org/topic/339927-what-are-you-working-on-right-now/page/35/#findComment-2772269
 
Might work in your case but you would likely have to get the chrome plating stripped before any soldering attempt
 
After the Opel is done of course!

elipper, I just finished rebuilding my 1933 8-105 engine and did some research on plug wires and ends. I used the W-18 plugs. I had to blast & blacken plugs for show. The 1Com plug has the correct screw on wire end that I could not find replacements for. The plug wires shown I believe to be the correct colors. Thanks
Eric
 
I wouldn't kick your car out of the garage for the chrome! Somebody wanted to personalize their car , good for them, and its all easily restorable to original if you are bored or looking for trophies It's not like you can see it if you are actually driving the car.
 
Still curious what sparkplugs you had in it before you changed to the W18's, I have an assortment of plugs for cars that are not running so I may be getting ahead of myself (as usual )
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.



