Sounds like the master cylinder failed and needs a rebuild. I'm not familiar with this master cylinder but others will be giving advice. I answered this on the ACD Facebook site too.
 
 
Gary Parsons
It is very similar to a L-29 Cord Cyl. I will check for the NAPA rebuild number.
CORDially Mike
I picked one up at the local NAPA, and they have changed the design. The piston still fits, but the side of the piston where the rod to the fork for the clevis pin will not work. They have made the piston hollow, so the rod will now be short by 2 inches. Also, the lock spring is now a "C" clip.
 
I will modify the piston by filling the hollow end with epoxy and drilling a small dimple to replicate the original.
 
I have located the correct crush washers and purchased some loctite.
 
I'll upload photos once all the parts arrive and I reassemble.
Thank you to the members who helped me with this here and on Facebook. All is sorted now. The leak is coming from the cylinder and portioning distribution cap threads. Crush washers, although the correct size, would still not seal it. Over the years, DOT 3 corroded the mounting surfaces so a crush washer would not seal. I went with a McMaster Carr neoprene gasket and a few drops of Loctite on the threads. For the new style piston NAPA uses, I added 2 inches of piston length by adding a 7/16" - 20 coupler with some all thread and locking nuts. I Did an entire fluid swap while I did the bleeding. The car had been converted to DOT 5 years ago, so I just refreshed it with new DOT 5 fluid. Adjusted the brake pedal to within 1/2" of engagement with the piston, and she is all good to go. Now I have a Fuel Pump diaphragm leaking fuel. I will start a new thread.
 
Glad your brake issue was fixed. Things do seem to happen when we look at our cars cross eyed....
 
 
Gary Parsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.










