This could be coming from the thermostat housing. But the head can be leaking from the inside out without a crack if this is a original head. This can happened with a small pin prick of a hole that will gradually get worse. Clean every thing up and dry it off and watch for a small drop of coolant seeping out of the head. If this is the case you will need a new head as the corrosion will just get worse. As far as head bolts go I use 50 lbs torque on Alum heads. This should be done in a circular pattern starting in the middle and working toward each end of the head. Before I would try and "reseal" the head bolts I would first made sure the torque is 50 Lbs. For head bolt sealer I use good old Permatex No.2. If you use RTV sealer and retorque the head the RTV has set and when retourquing is done the RTV sealer is torn. The above is one persons opinion. I'm sure there are other opinions with merit as well.
CORDially Mike
Thanks for your recommendation. I cleaned off head and wrapped paper towel around base of thermostat and head bolts to check for leaking.
Then I cleaned head and am waiting to see whether drops appear.
I will report what I find.
If you find no leaks, run the engine till hot and watch for leaks.
CORDially Mike
You might try flattening the thermestat housing neck with 180 paper on a laping plate or some other kind of flat surface. They are just about always not flat.
CORDially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
