Its admiral you got into this three brush generator that deep. Did you bed down the three brushes to the copper commutator? Have you tried moving the third brush to see if that allows a "faster charging start"...
 
 
Gary Parsons
Bedding down the brushes is making them fit the copper communicator perfectly. You wrap a piece of 300 grit sand paper around the copper. Then hand spin the armature a few times. It wont take much. clean it and thats all it takes.
 
 
Gary Parsons
I have a PDF excerpt of a "Standard Auto-Electrician's Manual" that shows Volts and Amps for various RPM's.  During one of my nightly sleepless times this morning, it dawned on me the chart must be for engine RPM's, not generator RPM's.  So I calculated the equivalent generator RPM's from the pulley ratio.  I tested the low and high end RPM's on my drill press. Voltage is about where it should be.  I played around with moving the third brush and at the upper end of the speed in my chart,  I'm getting about 15 amps when I have two 12-Volt bulbs across the battery.  I'll leave it where it is for now and wait until I have the car restored to make the final adjustment with everything wired up.
 
Note, the voltage comes up much faster now.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
