Were the cylinders bored? I think the compression should be more like 85 to 95. Did you have the carb. wide open when doing the comp. check? Are the valves adjusted properly? Was cylinder head and block surfaces flat? Is cyl. head torqued properly? Comp. gauge accurate? Just some things to check.
CORDially MIke
What makes you think you have a compression problem? If you installed new pistons and rings but have not run the engine the rings will not have seated in the bores. Thus you will not have good compression untill the rings have seated. Thats presuming the cylinders were honed with a cross hatch pattern. Heads a blocks should be checked with a machinest straight edge!
CORDially MIke
Things are moving along and progress is being made. May now need a set of gaskets for the Shebler Mod U carb. Does anyone have a source for these?
Thanks
Also, I guess that I need a thermostat. Does anyone have a source for theses? What temp would be best?
Thanks
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
