I can highly recommend Optima 6 volt batterys. Plus you don't have to worry about fluid levels and they are considerably lighted than a conventional battery.
You can also get a mock up cover to make them look like a conventional battery.
They are rated at 800 CCA. Starts a Cord V8 easily.
Andrew If you need two batteries and 1600 amps to start the car you have other problems that you are masking. One battery is more then enough to start an Auburn.
 
The down side to the Optima batteries is they do some really funky stuff when they start failing. Several times I've worked on cars that were having strange electrical "ghosts" that I couldn't find. When I finally changed out the Optima battery all the "ghosts" problems disappeared.
The car will start fine with one battery. The old type of batteries used to be cranking at 1200 amps. The optima only do 800, so we decided to do two for that reason. The starter will only pull however many amps it needs to turn the engine over. We felt that there was no point in the battery or wiring being the limiting factor when it came to starting the car. We are not the only ones running this set up on our cars. We also didn't like how one battery sat in the holder. Many people carry two of them in there holder, we thought why not connect them.
Not sure what problem we would be masking up by doing this, if you have any ideas please let me know. We are always trying to have the car run the best it can.
Andrew, The rating system for batteries have changed from the 1930's to today so you cannot do a straight comparison of the numbers. a 600 to 800 amp battery is more then enough to start these old cars. If your electrical system is in good condition, your engine is tuned properly and you know to start your car(they all start differently) then they fire off on the first revolution.
 
I agree with Curt. It only takes a couple of ohms of resistance in the starting circuit to cause starting issues..
 
Wiring for 1600 amps is overkill. 4 ought cable is hard for the average person to get and is even harder to bend and run in these cars. If you ever have a short you are going to have major problems very quickly.
Curt is correct - when restoring a car there is often too much paint - think metal to metal contact (ie paint everything together verses painting everything all apart so that for example your bell housing has metal to metal contact with the block and is just not grounding through bolts). Also, I have the bell housing cleaned of paint under the started face (and the stater was rebuilt thinking metal to metal contact as well). Also, Curt is correct that the brush holders in the starter are riveted and if you drill out the rivet you often will find rust on the end plate and/or rivet holder.
 
The one thing I will say though is that it does not take long to loose a great ground to get marginal grounds and then seems a while longer and you have no grounds (Andrew had to deal with grounding and battery issues on our car after it sat from ACD Meet 2019 to ACD meet 2021)
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
