The cooling system is not a pressurized system from the factory.
CORDially Mike
Hi Mike,
It is understandable then , that a fuel cap might have worked in a pinch.
So , unlike today, checking coolant is an important part of daily startup.
Live and learn
Thanks
George
Thanks for your response, John,
I did install a non-pressurized cap and it seems to be running fine. I checked the radiator temp on a hot Chicago day with an infrared heat gun. The radiator seems to run about 185Ôü░F with no hot spots, and a 10-15Ôü░F difference from top to bottom.
In my opinion 180+ is too hot. Car should be running 160 with a 160 stat. I also use a 6 bladed fan from Summit. Rad. should be cooling 20 to 25 degrees top to bottom. That is my experiance with my 35 Auburn. My L-29 Cord runs this temp. also.
CORDially Mike
I should add that the rad. core on my 35 Auburn has been replaced with a high efficiency core and the L-29 Cord has a high efficiency core and made thicker. I don't like to screw around with overheating cars!!!
CORDially Mike
No, local rad. shops. Nothing special, just more fins and tubes. Granted it was 15 to 20 years ago. Also have always used Rad. filters.
CORDially Mike
Yes Curt, that is correct. L-29 core was not a honycomb originally.
CORDially Mike
You should not be losing too much coolant; the level is typically just below or around the bottom of the filler neck. You can place the hood in the space between the cowl vent and the cowl, then insert your head into the filler neck with a flashlight to check the level (putting the hood in the hood holders on the radiator support bars will not allow enough room to see into the radiator). If you fill it up too high, the overflow will simply spit the coolant out.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
