I recognize that frame. Are you from Canada too?
Pete Kelly Kincardine ON
Text with clutch pictures disappeared. Bellhousing is part of block. You need that for clutch/ brake mounting. Get parts and supplement early on. Has exploded diagrams and parts numbers helps alot. Museum has those.
Rear end could be auburn single speed. The dual ratio i believe was an option.
The rear diff shown in the earlier pictures is not Auburn . Craig, the engine block and the bell housing have two different partnumbers. You need the 1934 parts book and the 35-36 supplement. The diff is not 1934-1936 Auburn single speed. Yes ,the two-speed diff was an option. The Dual Ratio is what set Auburns apart from most all cars of the 30's . Cruise all day at 65MPH.
Life is Good.
When you get a moment send be some pix of your car .
cschulze @centurytel.net
Curt thanks for correction on bellhousing indeed being a separate part. I took a couple of pictures to illustrate that. In reference to original question about clutch and brake install. You really need to put engine, bellhousing, flywheel, clutch assembly, and transmission in as an preassembled unit probably how factory did it. Much easier! I've done transmission and clutch/pressure plate and transmission with engine moved forward a bit. It's a pain. 
Are you looking for a 2 speed rear end?
I am getting tired of moving one around my shop.
Problem is , I'm on the left side of the country
 
Brad
If you are going to run an original engine and trans , I would use the dual-ratio
diff. if you have a hemi, I would say NO. back in the day an Auburn six would stay ahead of Ford V8's and many other cars of the era. Heck, I had a restored 48 Chevy that would not keep up with or stop as well as the 6 cyl sedan.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.





