There is a three piece gasket between the body and frame.
The lower frame consists of three pieces a left, center and right.
The upper frame consists of a left anf right channel.
All or the part numbers are in this book
Literature: Auburn Part Number List Addendum for 851,852 Supercharged Cars $30.00 Ea R 35-36 8 Supercharged Models Parts list
Pat. I can confirm that my replica car also has the exact same number of separate parts as Curt has described. I believe the 3 parts of the base were cast off an original car in bronze, then polished, then chromed. The 2 side parts butt together on either side of the middle frame part but are not welded or joined. Each of the 3 parts has a number of threaded rods which screw into the base of each part which sits on top of the cowl . To fit, each of the 3 parts of the base sit on the cowl with the threaded Rod going through holes drilled into the cowl and a nut is screwed onto the protruding thread inside the cabin. The two pieces of glass are fitted with suitable window setting tape, and finally the two top channels are fitted and screwed down on top of the glass and into the frame.
If you need to see more photos of this, I can email you some. Just send me a private message . Regards JEROME
Check ends of windshield frame. Looks tilted back awfully far.
CORDially Mike
Great stuff Pat. I love the Duesy style steering wheel. Your car build is a huge project so I take my hat off to you for persevering. Re your windshield frame, in my case, on my Auburn Speedster replica, I spent literally days ensuring the base of the brass windshield frame perfectly matched the profile of the cowl. Perhaps you have that challenge ahead of you. Obviously your photos show the windshield frame somewhat randomly resting against the cowl and it is not affixed to the body in the correct position.hence the gaps at the end of the frame.
I can see that you will need to extend the center point end of the brass windshield frame so it extends to the point where your hood starts so some brazing and extension required, unless Duesy cars donÔÇÖt match Auburn speedsters in their treatment.
 
Anyway, itÔÇÖs a great project and you are doing a great job. What state do you live in? IÔÇÖd love to see the car someday
 
Regards JEROME
Pat
I understand re skinning the car.
If IÔÇÖm in the area I will definitely contact you. IÔÇÖd certainly love to see your car. ItÔÇÖs an incredible project and I certainly think i cod learn a lot from you
Regards j
Jerome
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.





