Andrew, a cylinder hone and some oil on the hone pads and cylinder (repeat a few times verses spinning rust everywhere) will clean up anything purely cosmetic in rust, but from that point you need to make the decision if you are just putting it back together or if you are going to bore and go with a oversized piston (most of us are running Aries Pistons from LA, CA in our 850/851/852 cars).
 
As to water jacket rust - go with say Evaporust or even vinegar (just cap all the large openings and let it sit for a few days). For scale rust you probably need to pick at it with something sharp and then repeat Evaporust. If you "boil" block out then you have to remove the bearings (but having had 8-90's I would say everything is poured babbit so boiling block would just destroy all the bearings - leading to probably a lot of extra cost).
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
