Help is on the way.... My thoughts are you need to run a tap thru the hole to clean the threads... But wait, there's more. These threads "MIGHT" be an interference thread to keep from loosening up during travels. I know my Ford diesel has an interference thread exhaust bolt but the heads are normal 3/8 course threads. If the threads are dirty use a thread cutting oil with the tap. Or some Aerokroil so it eases the friction. Its after 2 AM here on the West Coast so hopefully in a few hours others with first hand knowledge will chime in. Its not likely in my understanding of the Auburn financial condition that they would actually create a thread that was not standard to the industry because of the cost .
 
 
Gary Parsons
Thanks John and Gary
Finally found one of the misplaced screws in the labelled baggie I put it in!
Thread is #10-32 by all accounts so I held my breath and ran the tap through , with only some rust and paint particles coming through. Whew!
I have tried to chase threads on some of these older fasteners and find the fine threads really don't like being chased. they are just 'off' enough and the steel seems to be different enough that it makes a hot mess of the threads and an unusable fastener.
Any thoughts on the steel v brass plating question?
 
Brad
Brad, Don't use modern taps and dies to chase threads on these old cars. The spec's and manufacturing has changed just enough to cause problems. Get a set of rethreading taps and dies. These have greater clearances and are made for chasing threads, not cutting new threads. They work very wekk and won't damage the old threads but will clean them out and correct any problems with the threads.
Jim
Jim
 
An excellent suggestion !
I've been meaning to get some of those and keep putting it off which , as we know, inevitably leads to trouble!
 
Brad
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
