Kurt,
Thanks on the jets,
what spark plug do you use ??
Thank You Paul
Thanks Kurt I've been following you on the forum.
My 851 is not s/c.
I thought the std 851 plug was a Champion J6.
But I not trying to stay original with the plugs
Would you continue the J6 to get clean burning.
Does your carb. float have a hole in it and has sunk to the bottom of the bowl. Would cause most of the problems you are having. Not sure what you mean by "set the dist. at upper limits of advance"? 93 octane is not needed for that engine. If you are removing the valves might be a good time to grind them if needed. There was a article in the Newsletter some time ago about how to do that in the car.
CORDiallyMike
Hi Mike,
Been ready your comments on line on other matters.
Thanks for the tips on the gas octane and Carb float.
I'll check on the carb during the re-build.
Big Thanks, Paul
Scraping carbon off these old engines is pretty common. The compression ratios are so low they aren't very efficient. The temps they run at also don't burn carbon like a new vehicle running 210 degrees all the time.
 
Your powerjet/economizer in the carb could be leaking and it causes extra fuel to run in on lower rpm's. It's the jet under the accelerator pump.
Thanks Brad,
I've noted your suggestion,Starting with the valve cleaning and adjustment.
Then the carb .
I was thinking of using a non original carb and find a better carb that would fit.
The EE-1 has quite a history.
Thanks again.
Paul
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
