Take pictures with your phone as its taken apart.It really helps you when putting things back together. Remove the top plate by the two screws. Lift off. Then if you need to remove the internal shaft yes, That pin needs to be pushed out at the bottom. To remove the weights you need to remove a small internal snap ring in the top opening where the rotor covers when in place. Watch for washers in the bottom area too. You might be able to purchase any worn parts from Curt or Stan too. I have restored a couple for my 37 Cord and they are nearly the same. Just do a search in the 810 812 forum under 1748 S
 
 
Gary Parsons
The pin on the gear can be very hard to remove. Unless bushings are bad leave it alone. Clean the shaft area by removing the grease cup and cleaning through there. Just worked on one for a friend with hardened grease in the grease cup and was able to clean it in this manner with out removing the gear. His turned hard also.
CORDiallyMike
When you say contact piece, are you talking about the stud with contact. If so I can send you some.
CORDiallyMike
I have the missing contact you are looking for.
Send a PM with your address. George van Nostrand
Hi Paul
Did you find the small spring clip?
Pete
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.









