Welcome to the club. First thing is check the temperature of the coolant. These original radiators were Jamestown or Modine honeycomb core. The overflow is kind of odd. The tube running from the top drivers side down to the bottom of the radiator is set inside the bump out on top of the radiator top tank. So it can push coolant out when it expands to the overflow tube in this bump. It does not work like a modern day radiator cap where pressure pushes open a spring and allows coolant to pass to the catch can. Our cars do not catch the overflow. Then from there you have plenty of possibilities why this can happen. I do not feel the water pump belt is slipping but look for it to be loose too. Then finally the heads could be lifting causing combustion gas getting into the cooling system causing over pressurizing the system. But one set at a time. No rushing this. A simple idea like replacing the water pump belt is a major job. The pump has to come off. The distributor needs to come out. Its a big job but plenty of help to guide you thru it if you choose to EVER replace the belt.
 
 
Gary Parsons
Hi Vettepit,
The first question is the car actually overheating or is the radiator just too full. What is the temp gage reading? Do you have a infrared temp gage you can check the temp in the top radiator tubes and compare to the temp gage.
Also what is the water level in the radiator? If you are too full the water will expand and pump out but will stop when enough gets out. When cold you should be about 2" below the top of the radiator.
Let us know what you find and good luck with your "new" Cord.
JIm
I agree, if you overfill the radiator then it will find its own level and pump that out the overflow.
 
The next scenario is a bad water pump sucking in air.
 
And the worst scenario is bad heads or bad headgaskets.
Rad. plugged will impede flow.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
