All this sounds terrible but... How have you determined these dimensions? Personally I WOULD NOT take that much off the head or the block. As to answering the question of using a straight edge on the block. I suggest you use ONLY a true machinist straight edge. Any other straight piece of any level or edge is going to be "close" but not straight. Hopefully you will find these 25 thousands mearurements are untrue because of how you measured them. Everything in my personal shop is the Starratt brand micrometers, calipers and depth gauges. They are expensive but you get what you pay for. Nothing less like some of the other cheaper brands made overseas or worse.
 
 
Gary Parsons
Here are specs. from 1931 when copper asbestos gaskets were used. Block flatness Good .003, Fair .007, recondition .010. I have usually found that block flatness is usually good. .020 on head is too much.
CORDiallyMike
Who did you talk to at Olson's? Have not heard of that issue.
CORDiallyMike
It is my experience that 31-32 heads are cast iron and 35 36 are all aluminum.
All were cast flat.
Thom has the 31-33 Auburn with the iron head; not a problem with them that I know of.
Pete
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
