LA
@lance@ddclassic
Replies (17)
J
I can photograph, though not heading that way for a few days - if someone can beat me to the punch, please go right ahead.
 
As a sidenote - the pan in the bottom of the grill must be in place prior to assembly of the grill/hood and is necessary for proper cooling of the car (no exceptions).
L
Thanks
M
It also helps to seal the sides of the radiator, although that is not orig. I used pipe insulation slipped over the sides.
CORDiallyMike
J
This is actually a photo of the engine splash pan that goes under the harmonic balancer on front of engine. [attachment=4569]20200515_162006.jpg[/attachment]s correct.
Y
John yours looks nicer! Should it have body webbing under it like mine? You can see it at the front corners.
C
Look in the 34 parts book, page 22, there is a blow-up diagram . 34,35,36 are all the same.
L
i am waiting on a parts book for it. I wont have it tlll some time next month from ebay
J
Mine only looks nicer as it is painted in gloss black and that is a double edged sword as I am not sure what finish would be better long term for cleanliness (what does not show water marks and dirt). The original finish was chassis or satin black. As to the webbing - I do not know, but yes, dad's 35 has webbing and the other two cars did not, but then again I was not the first people to touch them. I like to use glass setting tape as webbing.
Y
Top of Page 83 in 1934 parts book lists 4 pieces of anti squeak for front dust shield and 4 pieces for the side "shield" s?.
C
All dust shields are semi-gloss black. There is thin webbing between the frame and the dust shields.
Y
Most of the scraps of webbing I've found on Auburn frames is black. Is that correct? Most are oil or tar impregnated so I can't tell. One scrap appears brown in the middle.
J
You will never see the bulk of them - I am fond of glass setting tape. Something in the brown to black range is fine enough, but yes they appear to lean toward black-ish.
C
They were fabric, some had as much as 1/2 inch hanging out the end (s).
I
That is an air deflector, not a dust shield, just so you know....
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.





