The short answer is YES.... But you really need to check clearances in several places to make sure nothing is worn causing huge pressure loss issues.
 
 
Gary Parsons
our 1927 8-77 at about 40 mph sits on 45 psi and drops back to about 25 psi at very slow idle retarded, this is with hot engine.
Ivor.
Do you have a oil filter on the engine? If you have a filter it should have a restrictor hole on the inlet side of the filter. If it does not have a restrictor hole much oil will dump through the filter and not go to the crankshaft and cost oil pressure.
CORDiallyMike
OK the plot thickens. Now I am hearing a rattle from underneath my Timing cover. Sounds like the chain or something came loose under it. It looks like I have to pull the motor to do an inspection. Correct? If so,Who can rebuild my steering box for me? It needs help.
Thank you
If I remember correctly you need a special bolt to hold the cam sprocket on; do you know if that is what was used?
Pete
I do not. I bought the car with the impression the Engine was rebuilt. Like the rest of the Car, I probably need to go through it again to look for shortcuts.
Thank you
If you didn't get recipes of the rebuild all bets are off, sorry to say.
CORDiallyMike
Not sure about the oil pressure issue, most photos I see show after market cartrduge filters from the 50's ( like mine!)
Mike, can you advise what size the restrictor orifice should be?
 
As for your steering box question, I sent mine to Lares .The voodoo they did was about $700. I don't think there are any other options . Finding bearing parts for the sector tapered bearing peg is impossible. I don't know what Lares does in there and I'm not about to take it apart to find out!
 
Brad
The filters I use on my 35 Auburn have a .059 or drill No. 53 restrictor hole. I think my L-29 has the same. These are both partial flow filters, not full flow. Full flow filter would not have a restrictor hole!!!
CORDiallyMike
If you have something amiss with a" rebuilt" engine, check everything. It will give you peace of mind.
CORDiallyMike
Can you get the Balancer and timing cover off without pulling the motor?
I found the culprit on the oil pressure. It was the relief valve not working properly.It had the wrong spring in it.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


