I have never seen one of these throw-out bearing retainers in aluminum in any cars I own from 1910 to 1967.
CORDiallyMike
I'm on a business trip in Michigan. When I get back to Indy, I'll take a picture of the part & post it. It's a sort of bell shaped casting whose flange is bolted to the front of the transmission with a cylindrical tube projecting forward, through which the input shaft goes. The throw-out bearing slides on the OD of the said tube. The tube was broken from the base of the flange. I haven't unbolted it, but logic suggests the front bearing for the input shaft is retained by the flange, thus the name "Main Drive Gear Bearing Retainer." It is not magnetic, so it's either cast aluminum or some cheap pot metal, which surprises me. But I suppose it's not considered load bearing, so cast iron wasn't used. Nevertheless, I think it was made cheap.
 
For now I'm cleaning & repairing engine accessory parts like the oil pump, generator & starter, so I haven't thought about this part much for the past couple of weeks. I think I'll end up having that part fabricated.
Hello Bruce, On the earlier Warner Muncie T64 gearboxes the main drive gear bearing retainer is cast iron, the clutch throwout bearing slides on the extension, if a replacement is not available it could be easily machined in steel. If you get one manufactured I would consider machining it to allow a oil seal to be fitted, the early ones have a scroll thread labyrinth seal that works well but would be easier to fit a modern spring loaded lip type oil seal.Ivor 
Are you sure this has not been altered in the dark past? Make sure before you start making new parts.
CORDiallyMike
You raise a good point, Mike. I'm certain someone changed the clutch at some point. The clutch pressure plate had almost no rust. Then I just had the clutch rebuilt and the shop found a helicoil in the flywheel for one of the clutch mounting bolts.
 
And then there's the throw-out bearing seized to the extension tube of the front bearing retainer, which is the subject of this post. Perhaps whoever replaced the clutch installed a cheap aftermarket bearing retainer. I just don't know.
 
I have the engine and transmission out of the car, so I can check the fit of everything in the assembled and disassembled states.
Could be they could not get the correct throw-out bearing and made something to fit the bearing they could get.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.



