The nominal cylinder bore is 2.875" Lycoming would have had a machining tolerance on this like 2.875" +0.001" - 0.000 and the invar strut pistons would be machined to have the correct clearance of 0.0015" to 0.002" when measured at right angle to the piston pin just up from the bottom of the skirt and checked with a 0.0015" x 1/4" wide shim in the bore. For the main bearings the nominal diameter is 2.375" and the con rod 2.125" the crank journals would be ground to give the correct clearance of 0.0015" to 0.002".
I
· Jul 31, 2019
Thank you Ivor!
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.