Hello Curtiss, To set your mind at ease I recommend you check the actual valve timing as it is important it be correct for your model. It is easy to do if you have the head off and with a magnetic base dial indicator or cigarette paper under the valve head you can check when the valve starts to open. To do this you first need to set the valve clearance to 0.010" on say number one cylinder (note this is not the running clearance) then check the actual timing as per the chart attached. For your 8-105 It looks like it should be Intake open 5 deg before UDC and Close 40 deg after LDC. Exhaust opens 50 deg before LDC and closes 10 deg after UDC. Good luck.
Curtiss If you are 100 percent sure that there was only twelve links between Cam and Crank gear marks I would put it back that way. As Ivor shows in a previous post it also showed 12 links in between . I have a 1933 Motors manual and it also says 12 link pins between punch marks. As for setting the valve clearance, It really has nothing to do with the timing chain marks. If chain is put on as it is supposed to be you can do all the settings later.
Hope this helps Terry
Not valve clearance, but valve timing. Two different things. Valve clearance has little to do with timing chain. Valve timing has everything to do with the timing chain. A little change in a word makes all the difference.
CORDiallyMike
We are in perfect agreement Terry.
CORDiallyMike
I am installing the timing chain in the 8-105 and I am a little puzzled. The car was running find when I took it apart (other than the broke ring it had) and the picture below is how the old one was installed, it counts 12 teeth between the marks but the attached manual says it should be 13. 
Do I install the new one the way it came out or do I do it as the manual says? What happens if it is a tooth off? 
 
[attachment=3580]timing chain.JPG[/attachment]
[attachment=3581]Camtiming.jpg[/attachment]
 
 
Can someone comment on why this chain does not fill the complete gears and why it does not have a center guide like any other Whitney timing chain? Am wondering if this chain can handle the valve load to open and close valves.
 
 
Gary Parsons
I wondered about that and why the chain so narrow compared to the sprockets
when I first saw the pic. What will keep the chain on the sprocket?
Randy and Curt please fill us in.
Pete
Curtiss
I have a 1933 8-105 I am rebuilding. Before I took the chain off I took this picture and counted 12 pins between punch marks on the two sprockets at TDC #1.
Looks like your picture.
I was searching for a timing chain and ordered one from EGGE. They describe as a 49 link chain # TC403.  I noticed your chain looks narrower than my original, it does not go to
the edge of either gears. Did you end up running the engine as you have it pictured, 12 pins? And did you buy your chain from EGGE?
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.






