Make sure your drums are safe!
Dont pass up a useable drum.
I have 8 cyl fronts NO rears.
I have 6 cyl fronts and rears.
They all started out life with a 12" ID.
I would suggest posting this out in the general discussion board on the AACA site. This problem is not limited to ACD cars.
Terry I used to do this exact welding in the huge two football field size machine shop I worked in. When a damaged steam turbine bearing area needed rebuilding we could build up the bearing by continous welding a a rotating fixture. Because of the material we needed to keep the bearing area hot around 750 degrees F... That heat was done by huge propane tanks and burners we called weed burners. The welding machine was built by ARP. Fully adjustable welding speed and feed of wire off giant wire spools. Process was simple but setup was very difficult to get correct. It was TIG welding but the welding tip never moved
 
 
Gary Parsons
You may want to follow this thread :
https://forums.aaca.org/topic/325517-new-or-refurbished-brake-drums/
Interesting ideas coming up over there.
 
I spoke to wildwood at SEMA about disc brakes on my 851. They told me that that figuring it out would be between 15-25k. Beyond that it would
around the cost of a normal conversion kit . The disc maybe could be hidden inside the original drums.
I am a member of The Riviera owners Association and they have a ad. in their Mag. for aluminum brake drum relining. Don't know if they could reline cast iron drums. J&G relining www.jgrelining.com
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
