I have not had good experience with insert bearings if you drive a lot of miles.
CORDiallyMike
I agree with Randy on this. I asked him the same question on my 37 Cord engine. Was kind of disappointed with the answer too. With our older engines we deal with what we have. On another note its not impossible to have a crank shaft maker turn one for you.. But you best know a one off crank is really going to be expensive. Only you can say if that extra cost is worth it.We have a very good company out here in the LA port area that comes highly recommended for Babbitt work. I have not used them yet but plan to. My Babbitt are original to 1937. They need replacing because of the years in use.Hello .If you can find a good Babbitt bearing guy it should last your life time .Your four cylinder crank is not hard enough to handle hard inserts over time and it will wear the crank over time.
Thanks for the reply Mr Huffman, greatly appreciated. The second reply from Mr Ema has similar thoughts. Babbit it is and hopefully I find a place in Cape Town that can do the job. ItÔÇÖs a skill thatÔÇÖs fading away fast in South Africa.. IÔÇÖll keep you updated, sorry about the photo not sure what went wrong.
Kind regards
Anthony
Good day Mr Ema
Thanks for the response, also greatly appreciated. IÔÇÖm surprised about the response and will if possible stick with the baddit option.
Have a great day
Regards
Anthony
A friend had a crankshaft made for a 1910 Wayne. I said to him " that must have been expensive". He said they sent the crank to him in a big crate, he just filled the crate with money and sent it back!!
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
