The specs. for the 35-36 Auburn are .003 to .005 end play measured with a dial indicator. Don't know if it is the same for 32. I measured the bore and housing size and used a lip seal. You may have to fabricate a collar for the OD. Both sides do not have the same size on my car so be sure and measure both.
CORDiallyMike
T
· Jul 11, 2018
Thank you for the Info. I'm going to make a new part to retain the Lip seal. I think 005 would work on the end play. This I believe is for Expansion when the rear end gets warm so a few thou loose would be better than tight.
M
· Jul 12, 2018
The manual says anything more than .005 should be tightened up.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.