KE
@kenswheels
Replies (11)
Start with a check to see if the brake switch works then proceed to the turn signal switch wiring.
Good Luck
J
Check your ground. You may have lost it.
M
I agree with Jim. Strange phenomenon with lights is usually ground problems.
CORDiallyMike
K
C
A brake booster did not come on your car from the factory. The brake light switch is on top of the brake junction block that is bolted to the LH frame rail near the cowl. If you need a brake light switch, I have new ones that are impervious to DOT5 and judge well.
K
Hi Curt.
Found it!
Is there a way I can figure out if it's still working?
C
One side has a hot wire . Have someone step on the brake pedal , check the other side and see if there is power there.
K
Just to cheat, if I connect the 2 studs shouldn't the brake lights come on?
C
Sure, if the wiring is good and the sockets and the bulb is good. I thought you wanted to check the switch.
K
Little A, little B.
Checked the lights, they work.
Check the switch...Nothing.
Looks like I need a new one. Any trick to replacing it?
C
No trick. The originals were hex , so you can put a wrench on it. The old ones will fail with DOT5 . I can supply a new one that has the hex and will not fail with silicone fluid.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


