The best penetrate I have found in 50 years or turning wrenches is Aerokroil from Kano labs. If this wont free up a rusted thread apply heat to about no more than 200 degrees. Then cool with the Kroil. It can been seen to get sucked down into the threads and free up anything.Very good on manifold bolts. Run the engine till warmed up. Spray it when you shut it down for the night. Do this a couple of times. When rust forms on threaded surfaces it makes about 50,000 lbs of pressure on the incline threads making them tight. When rebar rusts in concrete it makes as much pressure causing concrete to stall or explode from the metal. That can be dangerous.
Another good homemade penetrate is acetone and auto trans fluid. Mix equal parts and apply it but.. Realize acetone is dangerous to your kidneys.
 
 
Gary Parsons
Penetrating Oils
 
Machinist's Workshop Mag recently published some information on various penetrating oils that I found very interesting. Some of you might appreciate this. The magazine reports they tested penetrates for break out torque on rusted nuts.
 
They are below, as forwarded by an ex-student and professional machinist. They arranged a subjective test of all the popular penetrates with the control being the torque required to remove the nut from a "scientifically rusted" environment.
 
 
Penetrating oil Average load
None 516 pounds
WD-40 238 pounds
PB Blaster 214 pounds
Liquid Wrench 127 pounds
Kano Kroil 106 pounds
ATF-Acetone mix 53 pounds
 
 
The ATF-Acetone mix was a "home brew" mix of 50 - 50 automatic transmission fluid and acetone. Note the "home brew" was better than any commercial product in this one particular test.
 
Our local machinist group mixed up a batch and we all now use it with equally good results.
 
Note also that "Liquid Wrench" is almost as good as "Kroil" for about 20% of the price.
 
Steve from Godwin-Singer says that ATF-Acetone mix is the best and you can also use ATF- lacquer thinner 50 - 50 mix.
 
ATF=Automatic Transmission Fluid
Acetone evaporates quickly. Seems like all you would have is ATF unless it was used very quickly?
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
