These blocks are known to crack at valve guides. Did anyone mag. before work was done? Did you put hardened seats in? These blocks are very thin in the valve seat area and when hardened seats are installed you risk breaking through to the water jacket.
CORDiallyMike
Mike before the engine reconditioning work was done on my 810 Cord block I asked the guy who runs the shop about fitting hardened valve seats. His reply was that "Hardened valve seats would not be required as the engine is fairly low compression and consequently would not get hot enough."
What are your thoughts on this statement and current knowledge in the US?
Thanks,
Terry
Hardened valve seats were in response of the elimination of lead in the fuel, not how hot the engines gets. My understanding is the 810-12's get plenty hot. If people can put hardened seats in safely I think most people do, although I don't know if it is necessary. I have put 55K miles on my Auburn with out hardened seats but with SS valves with no problem.
CORDiallyMike
My guess is someone damaged the block when installing new valve guides.
I never heard too much about 31 or 32 blocks and then all of a sudden seemed to be the topic at Auburn this year.
Sidenote: I agree with Mike - a standard seat with a hardened valve works fine, though I have been driving plenty of stuff with standard non-hardened seats and standard non-hardened or SS valves as well.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
