Thanks, the pinning method is defiantly out, the metal is too thin to thread in the water jacket and and the area is too hard to get a drill and tap into. I have also looked into spray welding but can not find anyone remotely near us and when they do that they have to heat the whole block which means my babbot came bearing will melt and that would need to be re-poured.
 
I purchased some Belzona 1111 metal epoxy and I applied it this morning and I just went down and took a spare blob I kept and whacked it with a hammer and this stuff is very tough. I am going to let it dry a day or two and see how it is once it totally cures. My issue it is very near where the valve spring is and I am worried about structure holding up.
I used JB weld, (a similar product) on a water jacket crack, and so far it has held up for 10 years.
The crack I had was 18" long, just below the sideplate cover. I made sure it was media blasted first, inn order to have a clean surface.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
