Thanks for the reply. I have the Dual Ratio rear end apart now and it looks pretty good. I do have about .012 clearance where the sun gear shaft runs in the case so I am going to replace that bushing. I have no bushing inside the sun gear where it rides on the support hub so I am going to add a bushing there. The sun gear on the left in the picture is out of another rear end and it has a bushing in the sun gear. The support hub is good but it is pot metal so I'm going to replace it with the steel one out of the other rear end. The 5 small gears have .004 clearance on the bushing and I thought I would run them unless someone thinks that is too much. Thanks for the help. Wes
Don't forget to check the pinion bearing, universal joints and drive shaft. The more revolutions of these items in low range might vibrate but not on less revolutions of high range. Just a thought.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

