I went down and looked at mine which came out of a running engine and there are only 12 links, I did not think they would run very well being a tooth off??? This one ran pretty good before it came apart.
[attachment=1829]20171225_091425.jpg[/attachment]
 
Any guidance on this, the procedure shows there should be 13 pins between the dots but on the one that came out of a running engine only had 12 pins between the dots?
 
I did not think they would run very well being a tooth off??? This one ran pretty good before it came apart.
Hello Curtiss,
As you have the head off it would be a good time to check the actual cam timing, from the information I have for the 8-105 you first set the valve clearance at 0.012" (this is for timing only not running) The inlet opens 5 degrees before UDC the inlet closes 40 degrees past LDC the exhaust opens 50 degrees before LDC and the exhaust closes 10 degrees after UDC. This should be in the 8-105 owners handbook and also in the 1930 and later service manual. If you do not have these they are available from the ACD museum store, the new store website is now up and running. Also see previous post by Mason Maynard 7th March 2010.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


