You might want to soak the engine in penetrating oil repeatedly and delay the disassembly for a couple weeks
Pete
A couple of years back a scientific study was done:
Penetrating Oils
 
Machinist's Workshop Mag recently published some information on various penetrating oils that I found very interesting. Some of you might appreciate this. The magazine reports they tested penetrates for break out torque on rusted nuts.
 
They are below, as forwarded by an ex-student and professional machinist. They arranged a subjective test of all the popular penetrates with the control being the torque required to remove the nut from a "scientifically rusted" environment.
 
 
Penetrating oil Average load
None 516 pounds
WD-40 238 pounds
PB Blaster 214 pounds
Liquid Wrench 127 pounds
Kano Kroil 106 pounds
ATF-Acetone mix 53 pounds
 
 
The ATF-Acetone mix was a "home brew" mix of 50 - 50 automatic transmission fluid and acetone. Note the "home brew" was better than any commercial product in this one particular test.
 
Our local machinist group mixed up a batch and we all now use it with equally good results.
 
Note also that "Liquid Wrench" is almost as good as "Kroil" for about 20% of the price.
 
Steve from Godwin-Singer says that ATF-Acetone mix is the best and you can also use ATF- lacquer thinner 50 - 50 mix.
 
ATF=Automatic Transmission Fluid
We completed taking the engine apart today, though a few of the cylinders were in bad shape we were able to get all of the pistons out. All of the rod and main bearings still looked good and had oil. The pistons and valves will need to be replaced and an overbore or re-sleeve in the holes. The cam looked good but the timing chain was stretched a bit.Will have to hit a machine shop to see what can be done. 
These blocks are notaries for cracks around the valve seats and in the valve guide area. Be sure and have the block magnafluxed after it is cleaned up. Remember that hot tanking it will remove the Babbitt. Don't invest too much money in it till you are sure there are no cracks. The long term success of repairing a cracked block are not great.
CORDiallyMike
As far as the "home brew" penetrating oil, what keeps the acetone or lacquer thinner from evaporating out of the mix unless used immediately?
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

