I had a intake valve stick and it did not backfire and lost some power. It would come unstuck and not stick again for several hundred miles. It would only tick for 10 or 20 seconds and then stop. It tried all kinds of special elixirs but only cleaning the guides and valve stems fixed it.
CORDiallyMike
Yes, and ground the valves while I was at it. If it continuously clicks do a compression check and see what you find. Not guaranteeing its a valve though.
CORDiallyMike
OK, I know this is an old one but still working on the fix 🙂
 
I have tried many things and the problem is now more easily repeatable but still there. I adjusted the lash, changed oil, ran some marvel in it, checked for a broker valve spring and still there.
 
I can now recreate the symptom by warming the engine a little than while sitting still rev it to 2000 or 2500 for about 2 to 5 mins then it will start ticking and it will have a miss but as soon as I let off the gas it normally goes back to a normal running engine.
 
At this point I am suspecting it is an exhaust valve since it is not backfiring or spitting from the carb side. I am thinking one or more of my valve guides is too tight and when the valve heats up it is expanding and sticking. I am to the point that I am going to pull the head and the valves out to see if I have a tight guide. I may go ahead and get a guide reamer and run it through each one.
 
My question is around tools, what valve spring compressor will work on the flat heads and is there anything I should be aware of tackling this?
 
Thanks,
Curt
I use the reg. "C" type valve spring compressor used on overhead valve heads. The lifter should be adjusted to give the most clearance to get the spring out once released. I use a screwdriver to bend and pry the spring put. I would avoid running the engine at 2000 to 2500 under no load for two to five minutes though. You may hear more than ticking!
CORDiallyMike

I just got the head off and it is looking like I have a pretty solid scoring in the rear cylinder and the top of the back 2 pistons had a thin coat of oil on them. I also noticed an inconsistent color in many of the valves by cylinder. I am done for tonight 🙁 http://phpstack-1081784-3880776.cloudwaysapps.com/media/kunena/attachments/6823/IMG_4097.JPG[/img] http://phpstack-1081784-3880776.cloudwaysapps.com/media/kunena/attachments/6823/IMG_4099.JPG[/img]
Well I dropped the oil pan tonight and removed the rod cap on number 8 which is the cylinder I had scoring in and sure enough the second ring from the top was broken.I looked at the Rod bearing and as I was told by a previous owner the rod bearings have been converted to inserts but they were in pretty bad shape as was the crank. I was at least able to get number off of the bearings so I can get them replaced. Now I have to lean how to decode bearing numbers 🙂

I think you are missing the oil drain back tube on the rear main.
The bearings are .020 undersized and were made in 8/06.
CORDiallyMike
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.



