Curtiss: On my 36 Auburn, I ended up drilling extra holes near the ends of the trim to help hold the trim in tighter.
Then re-positioned the fasteners as needed. (No one noticed the difference in the amount of holes)
Mark
Thanks for the answers and pictures, Debby and I got them drilled and installed last night. I ended up having to use some Chrysler molding clips I picked up from Fasenal to slide into the outer strip. I had to cut off the spring end but they worked great. Had to buy a box of 50 to get 10 🙂 http://fulloctanegarage.net/wp-content/uploads/2017/01/20170123_130145-1024x576.jpg[/img]Molding ClipsChrysler: 1624705 6010093 Universal Moulding Fastener https://img0.fastenal.com/productimages/0162646.jpg[/img]
I used the same clips, but instead of removing spring, I sanded off some of the top edge.
If you want to sell me the rest of your clips let me know. email is mspandikow@gmail.com
Mark, your car takes 20. They are flat-sided bolts that slide down the channel. Use square nuts, all parkerized black.
My 31 and 32 are the same, but take fewer fasteners.
Curt
 
How does one 'parkerize ' a modern fastener? And can you do it with stainless if one was 'nuts' enough to ? Any tips?
I've painted other fasteners on the car but that is messy and , as I'm sure you know, doesn't look quite right.
 
Brad
Brad, you can buy parkerizing kits on eBay, the instructions are easy to follow.
Stainless steel blackening can be purchased at Caswell. This is even easier, no heat required.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.



