Hello Curt,
I just adjusted my brakes on my 31. On the back of the drums there is a slot head bolt holding up a flat piece of metal, remove and you will see a brass adjustment wheel. I tool a brake spoon and ground it down to fit the wheel. Turn the wheel clockwise while you rotate the tire until you feel a little drag, do the same for all four.
Curt,
It took me an hour trying to figure out how to reply to your post, still didn't get everything in, so I gave up.
This new forum is the worst I have ever tried to use.
 
Richard
Awesome, thanks! I will give it a shot this weekend.
 
The new forum does take some getting used to.
Hi Curt
I sent you a copy of the brakes instructions from the 31 service manual; should make like easier.
Pete
Read the brake adjustment instructions Pete sent you and follow them to the letter. Don't take short cuts!!!!
Cordially Mike
Curt,
Got my service manual out and readjusted my brakes as per instructions. I had my brakes to tight, what I forgot was the block of wood under the pedal and clockwise to tighten and counter to loosen. My brakes are much better now but still squeaks, not sure how to fix that.
 
Richard
Richard, my comment was directed in reference to the ease of use of this website. But it is also true of the brake adjustment.
I will be doing this soon myself soon, how thick is the block of wood under the pedal. I do know the correct adjustment wrench to turn the little brass wheel goes a long way to eliminate frustration.
Hi Curt,
Three inch block, the drag on the front a little more then rear.
Merry Christmas
Richard
Found the solution to the squeakey brakes problem.
The product is CRC de-squeak. I took all four drums off and spray costed the contact surfaces in the drums. I drove it around the block, start and stop at least ten times and not a sound.
I would have bet you money this would not have worked, boy was I surprised.
Richard
Gentleman, it was anchor pin clearance I was thinking about, not shoe to drum clearance. It has been a while. I have it scanned, but nothing jumps out at me here as to how to share it to this thread.
Auburn 1932 Service Bulletin # 24, refers to 1931 Bulletin (6 pages on brakes) then states:
"Essential changes for best result are: Set all anchor pin clearances to 1/16ÔÇØ (one sixteenth inch).
Adjust brake shoes for equalization by giving the same drag on all four wheels (this drag should be fairly heavy), after this has been done, again set the left front anchor pin clearance to 1/64ÔÇØ (one-sixty forth inch) by lengthening the left front brake rod.ÔÇØ
After this it mentions that proper adjustment of the kick shackle (1932 & up) is important for best riding & brake operation.
Pete could you send me the instructions also? davew@totaltooling.net
I'm having the same problem
Thank you
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
